Troubleshooting

The power to my shower keeps cutting out....
 There are a number of reasons why the power to your shower is 'tripping'. 1: The shower should be connected via isolated fused spurs. If ...
Fri, 2 May, 2014 at 2:48 PM
Where does the wire for the outer LED lights go?
  On some models of steam shower there are LED lights fitted into the outer frame - these are very low voltage bright lights. The lights have a wire co...
Fri, 2 May, 2014 at 2:49 PM
I cannot get the glass side panels to fit into the curved frame; the glass seems to be too tall?
  The glass panel is factory cut, so will always fit, it’s just that it is a tight fit on purpose to seal the unit. To fit the glass side pane...
Tue, 3 Jun, 2014 at 6:04 PM
The doors are too short and I cannot get the runners into position?
We have found that the doors are easier to fit if you only put the top cam runners on first at their lowest position and hang them in place, then plac...
Fri, 2 May, 2014 at 2:51 PM
The grey end caps for the central uprights are a very tight fit, what can I do to help fit them?
  Place the end caps in boiling water to soften them. These are quite fragile and can be bent very easily, so we always suggest taking care when fit...
Fri, 2 May, 2014 at 2:52 PM
I cannot get the vertical uprights on the curved rail to fit now that I have built up the framework?
  From inside the cabin, you will see there are curved sealing strips screwed to the centre of the curved rail. Remove these, and you will be able to ...
Fri, 2 May, 2014 at 2:52 PM
There are a number of loose seals in the box, what are they all for?
The seals that are 1 inch wide with a lip running down one edge of them and holes located along its length are to be used between the central control ...
Fri, 2 May, 2014 at 2:53 PM
Fixing the glass on various shower models...
  To fix the glass panels that are positioned either side of the door in place you need to use the 'S' plate, which is a piece of metal with...
Fri, 2 May, 2014 at 2:57 PM
Glass side panels will not fit the curved frame - glass seems to too tall?
The glass panel is factory cut by machine, so will always be the same size and should therefore fit. The glass is however a tight fit and this is the...
Fri, 2 May, 2014 at 2:57 PM
Do I need to use sealant on my shower?
We would always recommend using a suitable waterproof sealant to seal the inside of your shower in a minimal way. Important: Ensure that the shower i...
Fri, 2 May, 2014 at 3:06 PM