The
water connections at the rear of the shower originate from the diverter
assembly. Connected to that are the two braided, flexible Hot and Cold Water
supply hoses.
These hoses are approximately 1 Mtr long and have 15mm Compression fittings. The end of these hoses should be connected to the Hot and Cold water supply in the property.
Ideally
you should ensure that you finish your pipework around 1 Mtr from floor
level in the corner for corner fitting showers, or in the middle of the
shower, if you have purchased a shower that fits against a single wall. It is also advisable to fit isolator valves to the ends of the hot and cold pipes.
Steam Shower | Shower Cabins | Whirlpool Showers